WPS ISO 15609 Template

Doc. No.:

WELDING PROCEDURE SPECIFICATION (WPS) (As Per EN ISO 15609-1)

Date:

WPS

Method of preparation and cleaning

WPQR No.

Parent Material Designation

Manufacturer

Material Thickness Range (mm)

Mode of metal transfer

Outside Diameter (mm)

Joint type and Weld

Position As Per EN ISO 6947

Weld Preparation Details (Sketch)* Joint Design

Welding sequences

Welding Details Welding Process

Run

Size of filler material (mm)

Current Range (A)

Voltage Range (V)

Type of Current & Polarity

Wire Feed Speed (mm/sec)

Travel Speed (mm/min)

Note:- 1.The upper limit of heat input shall not cross 25% more than than that used in welding the WPQR. WPQR. & The lower limit heat input shall not minimized 25% lower than that used in welding the WPQR 2.Weld joint area (covering 25mm both side) shall be cleaned by wire brushing. Filer Material designation and Make Any specific Baking or Drying Designation Gas/Flux- Shielding Designation Gas/Flux- Backing Gas Flow Rate- Shielding Gas Flow Rate- Backing Tungsten Electrode Type/ size Details of Back Gouging/ Backing Pre- Heat temperature Inter-pass Temperature Post - Heating Post Weld Heat Treatment (time, temp., method, heating, heating, cooling rates)* Other Information* Weaving (maximum width width of run) Oscillation (amplitude, frequency & Dwell time) Pulse Welding Details Distance contact tube/work piece Plasma Welding Details Torch Angle Other information : Date of Issue:

Location:

Prepared By

Reviewed By

Approved By

Approved By

Sign

Sign

Sign

Sign

Name:

Name:

Name:

Name

Date:-

Date:-

Date:-

Date

Heat Input (kJ/mm)