Wiring Installation (Et102)

April 25, 2018 | Author: Muhammad Shahrul | Category: Electrical Wiring, Electrical Connector, Electric Shock, Safety, Switch
Share Embed Donate


Short Description

Download Wiring Installation (Et102)...

Description

 Wiring Installation (et102) Muhammad Shahrul Anuar (06DTK12F1047) Mohammad asyraaf bin abu bakar (O6dtk12f1049)

Electrical Safety ( Safety and Safety ) •





Working Environment Safety Electrical Hazards Safety Practice

Electrical Safety ( Safety and Safety ) •





Working Environment Safety Electrical Hazards Safety Practice

Why safety is important ??? •





Safety Safety major is important to us because it prevent us to involve in accidents Accidents can happen to anybody so we should prevent from from happen to either to us and anyone else. This is so steps for us to take.. Okeyy !

Working environment safety … •





Make sure working place always tidy and clean from oil,water,grease and another alse.The objectives in order that we not slip or may cause electrical shock.

Working tools must put in safety place in order that not be disturbance. All tools and wiring accessories must be in good condition and to obtain deflect any accident.

Electrical hazard .. •

Electric shock hazards exist in many other places, thanks to the widespread use of  electric power in our lives. skin and body resistance has a lot to do with the relative hazard of electric circuits.The higher the body's resistance, the less likely harmful current will result from any given amount of  voltage.

Safety practice .. •

Before start working ..



While working ..



After working ..



Followthe safety rule and regulation ..





Personal safety .. •







We must wearing a suitable clothes for wiring installation. Shoes must be from insulating materials. During outcast a insulating from cable,use knife with careful. If use ladder,make sure ladder put in 30° on wall.

Wearing protection equipment .. •

Wear safety glasses to avoid eye injury.



Wear proper foot protection.



Wear a hard hat.

Open circuit (die circuit) •

All wiring installation must be doing in open circuit.The way to cut circuit is switch off the main switch or pull out the main fuse.

Closed ciruit (life circuit) •

Doing wiring installation or recovery work in closed circuit not recommended, except in urgent case.

Electrical Installation .. •





 Accessories Tools  Banananaaa ~

Hand tools

Locking Plier

Sledge Hammer

Screwdriver Phillips ( + )

Screwdriver Flat ( - )

Drill

G - Clamp

Combination Pliers

Long Nose Plier

Ball Pein Hammer

Adjustable Spanner

Connector PVC

Saddle And Bar

Inspection Elbow

PVC Box Switch

Intermediate Switch

Batten

Round Pin Socket

 Multi Plug Adapter

Fuse

Switch

Pemutus Litar

Inspection Tee

View more...

Comments

Copyright ©2017 KUPDF Inc.
SUPPORT KUPDF