Tape Reading -Using the Classical Tool to Decode the Market

Tape Reading – Using the Classical Tool to Decode the Market

1. Introduction "Tape Reading" is a classical method that uses to calculate the number of shares Accumulated or Distributed in a particular stock. It been used as one of the key tool to measure the "Internal Factor" by the Gurus, such as Jessie Livermore, Richard Wyckoff, etc... Combined with the "Technical Factor" of the stocks/market. The Proposition of how Tape Reading works is that The direction of the long term trends depends upon the amount of stock owned by and disposition of the insiders and key investors against the public. As Tape Reading can be use to deduce the Accumulation and Distribution activities, and even estimate the total percentage of shares in the insiders and key investors. Therefore it can use to deduce the price direction and level. Those who are interested in the original detail of how to do so can find out from some old classic book, such as "Reminiscences of a Stock Operator -by Edwin Lefèvre" or "Day Trading Bible - Richard Wyckoff", etc. 2. How does Tape Reading Methodology been Evolved... Volume Based Indicators While the "Tape Reading" methodology has be evolved over time and use in current charting indicators, it basic Proposition for the idea are the same: A) The manipulators/ insiders must accumulate enough percentage of the shares in a particular stock before they would mark up the price for distribution. B) The manipulators/insiders are having more information than the public, and would act before the public has notice the potential of the movement. The direct translation of the methodology into the current charting indicator is the On Balance Volume (OBV). The OBV calculation is basically adding the day's volume to a running cumulative total when the security's price closes up, and subtracts the volume when it closes down. There are many other variations, such as volume weighted moving average etc... All are based on the same idea that volume should move first (or to be more exact,

that the accumulation or distribution should start first), before the price would move strongly.

3. How and why does it loss it effectiveness For those who are seriously want to find out how effective of those volume based indicators, it can check it out by doing a throughout back-test of data since the indicators inception till current date.(Which would not likely possible for individual to do so). Or to check out the results in some books. "The Encyclopedia of Technical Market Indicators, by Robert Colby" is one of a good book for doing so. It can be seen that all these volume-based indicators were performing wonderfully well from 60's,70's and all of a sudden, in the 80's, they lost their effectiveness as an indicator for buy and sell. This is because there are more and more trading software available together with the Personal Computers, and computerized trading system for the big institution. Let me explain... For those volume based indicator that the public is using, they are mainly using the daily time-frame. So, the volume based indicator has made an assumption that the trading price and volume are equally distributed in the whole day of the trade. For the manipulators who would want to paint a picture of Accumulation, they can simple sell (distribute) the shares heavily, and just before the market is closing, they can suddenly buy back a couple of percent of what they had sold and push the price above yesterday's closing price. By doing so, all the Volume-based indicators will give false information. One can simple do an experiment to proof this... By collecting the one minute OBV, 15 minutes OBV, 60 minutes OBV and Daily OBV over a period of some time, say for two months. It would notice that there will be contradiction in the signals by the same indicators itself with different time frame. In general, the shorter the time frame, the more accurate it would be. But then the problem would be that most software are not able to handle years of 1 minutes data (Unless the user has to write special peace of code to compress the 1 minutes OBV and load it back to match with the daily price chart.)

4. How to correct these errors and bring back it accuracy Even so, that is to reduce the time frame down to a minute or second, there is still a problem with the accuracy in such volume based indicator. As there is one more factor that need to be consider... As today, the market is full of trading news in all sort of controlled media... So, when the manipulators wanted to purchase some particular shares, bad news would have came out to the public first, so that they can buy all the way down. For the classical method, all fall in price during the transaction are considered as a distribution, while all raise in the price are considered as a accumulation. And, in the Figure 4, it shows a snap shot of the Raw data of a typical transaction. Since the Bid and Ask are very dynamic, and for some high volume stocks, it can be transacted a couple or few tens of time within a second. So, the correct way to calculate the accumulated/distributed volume MUST take consideration of the Bid and Ask on the transacted price.

If the price is taken place on the Ask, it is a accumulation, and if the price is taken place on the Bid, it is a distribution. When one can collect the data as such for a particular share, then... over a long period of time... he can then decode the INTERNAL CONDITION of the stock. And, it must use together with others Technical Analysis Tool to get a better timing. For those who can understand this, it need no further explanation. So be it. Bless You. KH Tang

http://blessedfool.blogspot.com/

Relevant articles:http://blessedfool.blogspot.com/search/label/Stock%20Market%20Tool