note

January 8, 2017 | Author: kapenzia | Category: N/A
Share Embed Donate


Short Description

Download note...

Description

NOTE: Maximum horizontal fill of the groove should be 75 to 85%, as explained above in the circular gasket section. However, it is not necessary to fill the groove fully to 75% to obtain a good seal. Choose the width of ribbon that comes close to, but does not exceed, 75 to 80%. If one standard ribbon width fills only 70% of the groove and the next size standard width fills 90%, choose the size that fills 70%. As in the circular groove explained above, place the gasket so that expansion space is equal on both sides. The key point is that the cross-sectional area of the gasket remains the same while the cov

View more...

Comments

Copyright ©2017 KUPDF Inc.
SUPPORT KUPDF