JSA #19 - Heavy Lifting in Hazardous Area

Job Safety Analysis Sheet JSA Ref. No. JSA / KOC / 19 Facility: Work Area / Equipment: Permit No: Date: PERSONAL PROTECTIVE EQUIPMENT & TOOLS NEEDED FOR WORK ACTIVITIES: Hard Hat, Safety Shoes, Safety Goggles, and Hand Gloves. Job: Heavy Lifting in Hazardous Area

SEQUENCE OF BASIC JOB STEPS

POTENTIAL HAZARDS

Non-compliance of KOC -HSEMS Procedures, F & S Regulations

Yes / No

NO

PRECAUTIONS

•

Get the appropriate permits for heavy lifting activities in hazardous area. Refer “PTW Procedure”

•

Refer Chapter – 17 of Fire & Safety Regulation on “Lifting Equipment” for detail in this regard.

•

Conduct Toolbox Talk • Verify the suitability of lifting tackles & crane for the loads to be handled.

•

Check the Lifting Tools; Tackles & Crane have fitness validity, certificate and color coding.

Pre - work

• Collapse of the Crane & Load

Ensure the area is free from obstacles for crane operations and ground is properly compacted.

NO

•

Confirm the stability of the crane at work site.

•

Conduct safety check of the crane prior to start lifting.

•

Carry out the load test in case the crane is assembled at site. •

Fire

Lifting & Erection

Injury to Workers

Damage to the Load

Post - Work

House Keeping

NO

NO

NO

NO

Ensure that the load is secured for safe lifting.

•

Check for the availability of flame arrester mounted on the crane exhaust.

•

Carry out the gas test to confirm absence of flammable & toxic atmosphere at worksite.

•

Check the availability of suitable & approved Fire Extinguishers at site.

•

Check the slings, chain, ropes, eye bolt, pallet, container are not damaged and safe for lifting the load.

•

Verify the workers are trained for heavy lifting operations and non essential person leave the area before lifting operations starts

•

Confirm the signals between crane Operator & Banksman. Only trained Banksman to give signal.

•

Ensure no one rides on the load and nobody goes below the load.

•

Do not use Fork Lift for transferring long tublers / pipe rack.

•

Ensure the load safety before lifting and never overload more than the capacity of crane, pallet, container, slings / chain / ropes or tackles etc.

•

Lift the load slowly & check the slings / ropes / chains are not twisted keeping the load in central position.

•

Use the rope for guiding the load if required.

•

Use rubber pads to protect abrasion from slings. •

Remove the sleepers, slings and D-shackles

•

Make the area clean and tidy

Additional Hazards (Other than indicated above)

JSA Done By

Name: KOC / ID. No. Controlling Team: PMC/AMEC/KOC Signature:

Designation: SUPERVISOR Company: SKEC Contract No.(If Applicable): Date: