Gifts For Secret Code Drawing Origami Tome 1 PDF

 

Teddy's smile Didier Piguel See text instructions on last page Hoping you'll get it right, Enjoy, Didier

1

2

3

4

5

6

 

7

8

9

10

11

12

13

14

 

15

16

17

18

19

20

21

22

 

23

24

25

26

27

28

29

30

 

So, here are the steps to add a smile to Teddy Teddy : Caution :

do not use a square less than 35cm if you want to make Teddy Teddy smiling, at least le ast for your first tries.

1 - starting step to Teddy 2 - pull the mouth flap a little toward bottom, so that if you imagine you extend the lines of the edges of the colored nose toward bottom, you will meet intersection of this flap with head edge

3 - fold left side up 45° with vertical : the edge meets nose edge (reason of former step) 4 - unfold and repeat on right side 5 - Fold bottom point to intersection of creases made in 3 and 4 6 - Fold flap up, making a kind of rabbit ear using existing creases (landmarks are ends of line made in 5, and creases made in 3 and 4)

7 - result 8 - valley down on existing crease (along base of the nose) 9 - from 8, squash fold to the right. this photo is a "in progress" step 10 - result 11 - valley small flap to the left 12 - valley up 13 - inside reverse fold the small tip 14 – swivel up the tip 90° from the model plane. The goal is to spread squash it 15 - carefully spread appart the the two parts of the tip to make the squash. The bottom part will also begin to squash

16 - result after flattened 17 - valley down again along base of nose 18 - swivel left part up, with a mountain fold on top white triangle, and unfolding the small triangle on the tip

19 - result - repeat on right 20 - prepare an open squash fold with a valley fold at end of existing 45° creases 21 - squash in progress 22 - result 23 - valley mouth down 24 – swivel up mouth and one underlying white layer up - unsink ne next xt white flap (see 26 to see the result). This must be done by unfolding carefully that part

25 - view of the unsinking process, with the crease assignement of unsink 26 - result of 24 - see also step 28 to see the unsink flap above the mouth 27 - add 2 small valley creases to hide the white flap behind mouth 28 - valley down that white flap and the mouth 29 - valley down the unsinked flap, to teddy is now smiling :o))) 30 – Add mountain folds at bottom of head to round it FINISHED !!

 As you see, it adds a little more steps, but Teddy's Teddy's face is then so cute !  As you also see, it's possible to fold only Teddy's face, from a square folded in a preliminary base, and using just needed steps Teddy's diagrams.