Front Fender

| Page

Front Fender Open a new part with model units set to millimeters.

Go to: File > New > Part Select the three planes in the feature tree and make them visible by clicking on the glasses. Change the names of the planes Double click on the Front Plane in the feature tree. Change the name into: VERTICAL PLANE FRONT FENDER Double click on the Top Plane in the feature tree. Change the name into: CENTERPLANE FRONT FENDER Double click on the Right Plane in the feature tree. Change the name into: MIDPLANE FRONT FENDER Select the VERTICAL PLANE FRONT FENDER and create a sketch by clicking on the 2D Sketch icon Draw the sketch as shown in the picture. Start with the vertical construction line and circle. Offset the vertical construction line bi-directional by clicking on the offset icon. Change

into: 80 mm

Select the “Bi-directional” option.

Click OK Draw the other lines as shown in the picture. Trim all the lines you don’t need.

Add all the dimensions and sketch relations. | Page

Create a revolve Go to: Insert > Boss/Base > Revolve Axis of revolution

: Select the green construction line as shown in the picture.

Change the color of the part: Right click on the part > Body properties > Change color > Select the color you like. Click OK Select the MIDPLANE FRONT FENDER and create the sketch as shown in the picture

Create an extruded cut Go to: Insert > Cut > Extrude Direction 1 Change

: Mid Plane into: 200 mm

Click OK

| Page

Select the CENTERPLANE FRONT FENDER and create a new sketch Draw a vertical construction line starting at the origin. Draw a spline and add the right dimensions. You could change the shape of the spline by dragging at the tangency arrow. Design a curve you like. Mirror this spline about the vertical construction line in the middle of the sketch.

Connect all the dimensions with the origin. Use the SolidWorksModel part as  reference file if the 2D sketch is unclear to you (Extrude2, Sketch 3). Create an extruded cut Go to: Insert > Cut > Extrude Direction 1

: Trough All

Ensure that the offset is directed to the revolve. If not, click “Reverse direction”

Click OK

| Page

Select the VERTICAL PLANE FRONT FENDER and create a new sketch Draw a vertical construction line starting at the origin. Draw a spline

and add the dimensions.

Mirror this spline about the vertical construction line in the middle of the sketch. Connect all the dimensions with the origin. Create an extruded cut Go to: Insert > Cut > Extrude Direction 1

: Trough All

Ensure that the offset is directed to the revolve. If not, click “Reverse direction”

Click OK

| Page

Create a surface fillet Select the green surface as shown in the picture. Go to: Insert > Features > Fillet/Round

> 6 mm

Click OK

Hide Save

all planes and sketches except: VERTICAL PLANE FRONT FENDER MIDPLANE FRONT FENDER CENTERPLANE FRONT FENDER the file with the following name: Front Fender

Congratulations, you just finished the Front Fender! | Page