Checkpoint 

CHECKPOINT

STANDALONE-FIREWALL In Standalone-Firewall, there is need to 1 Firewall and 1 PC for manage the firewall. Installation of Firewall In firewall, you need to take 3 LAN CARDS. Here in the below figure there are three Lan Cards, one Lan card is used for inside network, second Lan card is used for DMZ(demilitarized zone) and third one is used for external network. Which contains the different IP. Now follow the below steps for install and configure to firewall.

Step 1: Insert a CD of checkpoint and press enter.

1

CHECKPOINT

Step 2: It show the welcome screen and ask for add driver but don’t need to add any driver just click ok.

Step 3: Here you have to select which type of system you want to install. So, select Secure Platform Pro and press ok.

2

CHECKPOINT

Step 4: Select US type Keyboard and press ok.

Step 5: Here we’ll see three lan cards i.e. eth0, eth1 and eth2. Select eth0 and press ok.

3

CHECKPOINT

Step 6: Here you have to set the IP address of inside network i.e. eth0 and press OK.

Step 7: Click on option Enable web based configuration. And insert Port No i.e. 443 and press OK.

4

CHECKPOINT

Step 8: It will ask for format your hard drive so press OK.

Step 9: Press OK to reboot your system.

5

CHECKPOINT

Step 10: Now firewall has been installed. Here you will see login window and also it will give web user interface access connect. We finished the firewall installation Now we have to install the PC for manage the firewall. So simply install the windows in PC.

Installation of PC & Configuration of Firewall via web Interface . Step 1: This is the windows 7 that we have installed with one Lan card that will used for inside network i.e. eth0.

6

CHECKPOINT

Step 2: Now we have to set the IP address and Default gateway.

7

CHECKPOINT

Step 3: Just open command prompt in PC and check IP that we had set as eth0 is pinging or not.

Step 4: Open internet explorer and type Address which is given in firewall as web User Interface access connect.

8

CHECKPOINT

Step 5: SECURE PLATFORM PRO will open in the internet explorer. Here we have to select agreement so just click on I agree.

9

CHECKPOINT

Step 6: Here Login screen will appear. So, put admin for both login name & Password.

Step 7: Now we have to change administrative name and password. Click save and Login.

10

CHECKPOINT

Step 8: First Time Configuration Wizard – Welcome screen will be appear. Now we are going to configure of firewall. So, click next.

Step 9: Now we have to set eth1 and eth2and status of all network should be UP. So click on eth1

11

CHECKPOINT

Step 10: Set the IP address and Netmask of eth1 and apply them.

Step 11: Set the IP address and Netmask of eth2 and apply them.

12

CHECKPOINT

Step 12: Now we can see all network is UP. So just click next.

Step 13: In Routing Table we have to set Default Route. Just click on New