Calibration of the APC 200.ppt

Linde

Service Training

Procedure for performing automatic calibration on the APC 200 transmission controller For the TE 27 transmission

Linde

Service Training

A Calibration has to be done when : when the vehicle is built at the OEM after each 2000 hours driving in gear (forward or reverse selected). when an overhaul of the transmission is done. when the transmission is repaired. when the APC200 is replaced.

When the driver complains about bad gear shift quality

Linde

Service Training

On the APC 200 we have a 4 digit graph display, 3 LEDs and to Buttons to select different functions

SPICER OFF-HIGHWAY

D

M

E F

S

APC200

The LED lamp labelled 'D' is yellow and is used to indicate test modes.

The LED lamp labelled 'E' is yellow and is used to indicate faults. The LED lamp labelled 'F' is red and is switched on when the APC200 is in the reset condition.

The M button is selecting the different display modes/ function groups See the description of the APC 200 The S button is scrolling in the different Display modes / function groups

Linde

Service Training How to do the CALIBRATION

S

M

To enter into the calibration mode Start the engine,press and hold the S button for 15 seconds

Linde

Service Training The engine starts The display shows

tran

S M

To start the calibration, press the button S again

Linde

Service Training The display changs to

Go

F

Now select on the gear lever FORWARD

The Calibration is now running in automatic mode The display will show the different stages !

Linde

Service Training

Linde

Service Training

When the calibration is done the display shows up

Now , stop the engine and the new calibration will be saved in the APC 200 The machine is ready for work again