Bolt On acoustic guitar neck

32.4 Dashed Lines Indicate Two-Way Truss Adjustment Rod. Cut Channel As Per Truss Rod Suppliers Specs

Access Hole For Truss Rod Nut

Hex Truss Rod Adjustment Nut

10.0

Truss Rod Cap

39.3

30.0

10mm Diamter Holes For Brass Cross Dowels - 2 Required

2" Brass Connector Bolts

Outline of Heel

Alternate Neck Connection Method Using 2" Bolts & Brass Cross-Dowels - Elevation 10mm x 16mm L Brass Cross Dowels. 2" Brass Connector Bolts Guitar Sides

22.0

19.0

Neck Heel. Same Wood As Neck. This Is The Contour At The Narrow Point Of The Heel. Quite Often This Contour Changes Depending On Luthier Construction Method.

63.0

22.0

Guitar Neck Block. Vertical Grain Hondurous Mahogany.

Dashed Lines Indicate Outline Of Heel At Back Or Bottom Of Heel. Shaded Areas Are Hardwood Laminate Pieces Epoxy Glued To the Tenon. Run Grain 90 Degrees To The Neck Grain

Drill 10mm Holes Through Head Block And Tenon For Cross Dowel Installation

10.0 4.6

21.7

25.0

25.0

Alternate Neck Connection Method Using 2" Bolts & Brass Cross-Dowels - Plan

This Drawing or Drawings Are To Used For One Use Only And Not Reproduced For Any Other Purpose Than Construction Of This Particular Instrument. Reproduction, Distribution or Sales For Any Other Use Is Strictly Prohibitied And Falls Under U.S Copyright Laws For Ultimate Guitar OnLine 2010

Date: Feb 15, 2010 Revisions:

Note: These Plans Are Drawn Full Scale Are Are Labeled in mm & Fractional Inches

Sheet Number